Search found 29 matches

by PG3
Sun May 28, 2017 12:21 am
Forum: SDRuno
Topic: Ctrl Panel & Main SP different freq.
Replies: 7
Views: 20906

Re: Ctrl Panel & Main SP different freq.

With a SR of 10 MHz and a DEC of 1 in the main window you have an IF bandwidth of 8 MHz. Each of your spectrum displays appear to be zoomed in and SCROLLED to different sections of the total IF bandwidth.
by PG3
Thu May 18, 2017 9:06 pm
Forum: SDR Antennas
Topic: Antenna ports
Replies: 4
Views: 19059

Re: Antenna ports

Replacing the RF blocking coil on the bias feed with a proper sized one (larger) would cure this... Not sure why a bias-t is included in the RSP since its need is antenna dependent and the bias=t belongs on the antenna side of an external antenna switch. With some circuit board hacking it might be p...
by PG3
Mon Apr 17, 2017 4:56 pm
Forum: General
Topic: No IF vs Low IF - when, why, and how?
Replies: 5
Views: 17013

Re: No IF vs Low IF - when, why, and how?

This question gets asked often and there are a lot of discussions on the net, just google it. Here is one thread that describes some of the trade-offs in simple terms...

https://www.dsprelated.com/thread/567/z ... -receivers
by PG3
Wed Apr 12, 2017 2:16 pm
Forum: General
Topic: Interference identification?
Replies: 37
Views: 95453

Re: Interference identification?

FCC caught with their pants down on the issue...
https://smartmeterharm.org/2016/04/23/f ... on-limits/
by PG3
Wed Apr 12, 2017 2:04 pm
Forum: General
Topic: HDSDR & SDRuno on one PC?
Replies: 4
Views: 13946

Re: HDSDR & SDRuno on one PC?

Before SDRuno version 1.12 you could have SDRuno, HDSDR and SDR# all loaded at the same time and just switch windows without having to close and reload each of them as long as only one was streaming at a time. It's quite convenient to not have to keep reloading SDRuno all the time as it always loose...
by PG3
Wed Apr 12, 2017 1:42 pm
Forum: General
Topic: what can it be this huge interference.... ??
Replies: 7
Views: 21286

Re: what can it be this huge interference.... ??

I have an ALA1530LNP and RSP1. I have found it necessary to ALWAYS have a MW (AM broadcast band) filter connected between the antenna and the input to the RSP (unless I'm wanting to chase MW DX in which case I replace the filter with a 20dB pad). The ALA1530LNP is very efficient at the MW frequencie...
by PG3
Fri Mar 31, 2017 7:55 am
Forum: General
Topic: Interference identification?
Replies: 37
Views: 95453

Re: Interference identification?

by PG3
Mon Mar 13, 2017 9:09 am
Forum: General
Topic: Interference identification?
Replies: 37
Views: 95453

Re: Interference identification?

Might be time to construct a monster Tesla Coil :P
by PG3
Mon Mar 13, 2017 6:14 am
Forum: General
Topic: Interference identification?
Replies: 37
Views: 95453

Re: Interference identification?

Are these PLC modems susceptible to any kind of interference that would make them inoperative?
by PG3
Tue Mar 07, 2017 7:44 am
Forum: SDRuno
Topic: Tuning
Replies: 3
Views: 11354

Re: Tuning

I would like to have different step sizes remembered for each mode. i.e. AM=5KHz SSB=100Hz