Search found 35 matches

by Harry
Wed Mar 08, 2017 1:05 pm
Forum: General
Topic: HDSDR w/RSP2 to HRD to a FTDX3000
Replies: 3
Views: 1180

Re: HDSDR w/RSP2 to HRD to a FTDX3000

Not sure why you are using DDE. I'm running HDSDR with HRD, SDRplay and my TS-990 using OmniRig and all works just fine. Everything synchs just fine.
by Harry
Thu Jan 19, 2017 1:19 pm
Forum: SDRplay related
Topic: RSP2 front-end protection?
Replies: 7
Views: 2542

Re: RSP2 front-end protection?

Ian, I don't think you're going to need the switch box. With the TS-590 S a switch box was required if you connected an SDR via the method described in the instructions. There is an alternative method that I used allowing a direct connection to the transceiver via a simple cable to the CN101 (attenu...
by Harry
Sat Jan 14, 2017 2:15 pm
Forum: SDRplay related
Topic: Use SDR while transmitting
Replies: 17
Views: 6042

Re: Use SDR while transmitting

That really depends on your definition of Nearby, how close the transmitting antenna is from the RSP receiving antenna, and the amount of power being transmitted. In general it is a VERY BAD IDEA to have a receiving antenna attached to any energized radio when a transmitting is nearby. Many compani...
by Harry
Fri Nov 25, 2016 1:34 pm
Forum: SDRplay related
Topic: Proposed upgrades to RSP1 no cancelled ??
Replies: 14
Views: 7313

Re: Proposed upgrades to RSP1 no cancelled ??

Hm, I would say most of the wishes for the RSP 1 have been recognized and the result is the RSP2. Only thing I don't like with the RSP2 is the high impedance antenna input for VLF and LF. I am using an active antenna there which has a 50 Ohms output. So the recent buyers of the RSP1 have funded the...
by Harry
Sun Nov 13, 2016 9:19 pm
Forum: SDRuno
Topic: SDRuno - Rig Syncronization
Replies: 7
Views: 1776

Re: SDRuno - Rig Syncronization

Heinrich, The OmniRig polling interval is 100ms. Again, not an issue with HDSDR or SDR-Radio Console. Further, the issue is not limited to slow polling and slow frequency change, but problems making frequency changes either from the transceiver via VFO or a rig control program. Works fine if I click...
by Harry
Sun Nov 13, 2016 2:34 pm
Forum: SDRuno
Topic: SDRuno - Rig Syncronization
Replies: 7
Views: 1776

SDRuno - Rig Syncronization

I've been using SDRplay for quite some time as a panadapter with my TS-590S, DXLab Suite, and OmniRig. Previous SDR applications including SDR-Radio Console and HDSDR have worked quite well. My challenge with SDRuno is its synchronization with the transceiver using OmniRig is funky at best. Below is...
by Harry
Fri May 13, 2016 9:49 pm
Forum: General
Topic: Connection to Yaesu FTDX3000
Replies: 10
Views: 6406

Re: Connection to Yaesu FTDX3000

It does help thanks As far as Amazon...what sort of search terms ? I tried 'SDR cable', 'SDR connector'...to no avail. As far as I know there is no "SDR Cable" or "SDR connector". What you want is a generic 50 ohm mini-coax cable with an RCA male and SMA male. So try something l...
by Harry
Fri May 13, 2016 12:56 pm
Forum: General
Topic: Connection to Yaesu FTDX3000
Replies: 10
Views: 6406

Re: Connection to Yaesu FTDX3000

I believe the FTDX-3000 has an RCA port. If so, you will need a shielded coaxial cable with RCA male on one end and SMA male on the other. With my HF rigs I use 50 ohm mini-coaxial cables for this purpose - either RG-174 or RG-316 - but that's just my preference. When ordering the cable be sure the ...
by Harry
Fri May 06, 2016 7:54 pm
Forum: General
Topic: TS590s SDR Play Combo
Replies: 8
Views: 3377

Re: TS590s SDR Play Combo

Thanks Harry! I will digest this document This is talking about using a PTT line for keying with the switcher, but I according to the document the switching uses RF sensing...(I've already tied up my Acc2 port for keying my amplifier.... Is it possible to use this setup and have an amplifier inline...
by Harry
Fri May 06, 2016 3:02 pm
Forum: General
Topic: TS590s SDR Play Combo
Replies: 8
Views: 3377

Re: TS590s SDR Play Combo

Thanks Harry I did see this, however I Don't want do any surgery to the radio. Hence why I bought all the external stuff, now I just need the hookup confirmed... Okay. Try the link below from the TS-590 Family Resources site. The link explains how to do this with an SDR-IQ, but there is enough info...

Go to advanced search