SDRplay Community Forum

It's probably the gain setting, by default it will be 3 or 4, change it to 0

If you are still having problems, posting a screenshot here (include the device selection panel so we can see the settings) will help.

Best regards,

SDRplay Support

In SDRuno 1.23 the SR button will NEVER appear when in Low IF mode. In addition to that the DEC button will NOT appear when a band button is pressed in Low IF mode. I would like to see some screenshots in case you have found a bug where those buttons do not appear outside of those conditions. Thanks...

The sample rate and decimation selection buttons only appear in certain scenarios. If you can attach a screenshot showing the problem and an explanation of the steps taken to get into that state, that would be helpful. For 1.23, please note that the sample rate does not show in Low IF mode and neith...

We have updated the HDSDR and ExtIO installers available from our Downloads page (https://www.sdrplay.com/downloads) to support the API 2.13 release. The purpose for the ExtIO plugin update is to support the API 2.13 which has an improved ADC overload acknowledgement system. We have kindly been give...

The IF bandwidth can be either 200, 300, 600, 1536, 5000, 6000, 7000 or 8000 kHz So for sample rates of 2, 3 and 4 MHz, the 1536 kHz IF bandwidth is used, so you will see attenuation of the signal outside of the IF bandwidth. At 5 MHz, the 5 MHz IF bandwidth is used, so that's why it looks "nor...

I would need to check, but my guess is that CubicSDR doesn't allow the display of negative frequencies? If you are only able to set half of your sample rate then this could be the reason. There is nothing in the hardware or API provided by SDRplay to prevent you from setting a frequency as low as 1 ...

If DSD+ can communicate via CAT, then SDRuno could be used that way - it will respond as per a Kenwood TS-480

Hope that helps,

Best regards,

SDRplay Support

It would have to be able to emulate Windows/x86 - even if there was an emulator I don't think it will have the power to run Windows, the emulator and SDRuno Our aim is to make SDRuno available on Mac OSX and Linux/x86 but that's it at the moment. I have no timescale for that. Best regards, SDRplay S...

SDRuno is an Windows/x86 application. It will run on small systems like a LattePanda or Intel Z83

Best regards,

SDRplay Support

If you are having a problem registering the device in the StartHere process (https://www.sdrplay.com/start-here) you can raise a support ticket at https://www.sdrplay.com/support and we'll help you. The API installation isn't dependent on the serial number. You will need to get the right API for you...