SDRplay Community Forum

This issue with the gain being incorrectly set after changing the 1st LO and some other parameters such as the sampling rate is a bug. It should be fixed in the next release of SDRuno. Many thanks for flagging this.

Sincerely

SDRplay Tech_Support

Dear Trevatxtal, If you look under the "Contact" tab on our website, you will find all contact details for the company including the one for support: http://www.sdrplay.com/contact/ All RSPs are shipped in plastic boxes with a card insert (inside the plastic box). All contact details are printed on ...

The support contact is support@sdrplay.com This is listed both on our website and on the card insert that comes with your RSP. There is Linux support for the RSP1 if you are having problems I suggest you email the above address. It is impossible to list a minimum spec for the RSP1 or RSP2 because th...

Hello Pete, What are you using as a reference source? Can you confirm that the SAM demodulator has correctly locked to your reference signal before you attempt the auto calibration? The signal needs to be within a few kHz of your VFO frequency and when locked, you will see a clean tone centred on 0 ...

To be fair Mark, this isn't a bug at our end. On step 3 of the 'start here' process we do ask people to disable any AV software for the duration of the installation process.

SDRplay Tech_Support

There will be a new early next week.

Sincerely

SDRplay Tech_Support

Sorry Mike,
We didn't correctly understand your question. I hope the new email we have sent you helps now.

Sincerely

SDRplay Tech_Support

Hello W5MCU, Unfortunately, SDRuno was a fairly recent addition to our software portfolio and because it integrates the API into the application, it doesn't sit well within the previous software installation flow, where we had to separately install the API and then plugins to interface to a piece of...

Hello John,
We recommend no greater than +10dBm for short durations and 0 dBm for continuous use.

Sincerely

SDRplay Tech_Support

What software are you trying to install? Did you follow the 'start here' process via our website? Normally if someone follows this and the installation fails for any reason, we will get an automatic support email request with details of what the problem is.

Regards

SDRplay Tech_Support