Exceptional piece of kit!

Post your feedback here
g,3vds
Posts: 12
Joined: Thu Nov 10, 2016 11:10 pm

Exceptional piece of kit!

Postby g,3vds » Sun Nov 13, 2016 12:36 pm

I have been using a Flex 1500 with a Wellbrook loop Rx aerial and a long(ish) wire as Tx aerial. So I am quite familiar with PowerSDR and I really like it and my little Flex.
A relative of mine who lives abroad recently bought an RSP1 and I was lucky enough to get my hands on it to try it out.

I had absolutely no trouble downloading and installing SDRuno on my little Win10 I5 micro PC I use for radio.

Running SDRuno with the RSP1 was a bit of a shock! It's a complex and very powerful combination. To new users I would say:
1/ Don't change any default settings until you're sure what it will do!
2/ RTFM ! And then read it again ..... And then read the Cookbook!

It's more difficult to drive than my Flex setup but much more adjustable. It covers a greater frequency range. It easily does an 8 meg sample compared to 48kcs. It has a few funnies but it receives very well on my Wellbrook.

Ok so it doesn't transmit

I've just bought one for myself !!
Last edited by g,3vds on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
G3VDS, NE5R

Return to “New Users' experiences”

Who is online

Users browsing this forum: No registered users and 5 guests