SDRplay Community Forum

I am getting this message every time I start up my RSP2, what can be wrong?

I've had the pov overflow come up a couple of times which I think was due to over-aggressive parameter changing on my part. In each case, SDRUno re-started ok. It may be that you set up a scenario that SDRUno just doesn't like and will throw the pov overflow when it attempts to start up with that "nasty" parameters set. I'd suggest that you un-install SDRUno and re-install it in an attempt to clear out any stored values in files that aren't immediately obvious to us general users.

Uninstalling and re-installing SDRuno will not help. You need to reset the registry settings in SDRuno. This can be done from within SDRuno with the latest version of the software. Please note that you will lose all stored settings if you do this.

Sincerely

SDRplay Tech_Support