Page 1 of 1
How to change Freq step
Posted: Mon Mar 05, 2018 6:59 pm
by fuel300
Hello, using a rsp1a on 40mtr ham band. the freq step tuning is locked on 100khz. Anyway to change it to 25khz or less?? 100khz making it difficult to pick out signal in the mud....i'm a new user---probably missed it in manual
thanks,
Re: How to change Freq step
Posted: Mon Mar 05, 2018 9:04 pm
by g1hbe
If you are using SDRUno, there is a bug which erroneously selects 100 KHz (instead of 100 Hz) when in LSB. You can correct it by following the normal procedure for step size selection as per the manual. The manual is available via the OPT menu.
Or you can hover the mouse over the relevant digit in the frequency display and use the mouse wheel to tune in any decade step down to 1 Hz.
I think the bug is due for correction in the next update.
Re: How to change Freq step
Posted: Wed Mar 07, 2018 7:50 pm
by fuel300
Thank you for your reply. I will investigate uno manual again, also using "hover method". I was away or i would have responded sooner---thank's again...