Buggy (?) Software?
Posted: Wed Aug 22, 2018 5:21 am
Hello All,
I recently purchased an RSP2Pro, and have been very pleased with it so far. The software though has been a bit troublesome for me though, and I was wondering if someone can shed some light on what is going on with my setup.
I am using SDRUno V1.22 on a Win 10 laptop. The software boots just fine, and can initially get the SDR to work. However, I notice that when clicking on any of the frequencies in the Memory Panel, I experience a few problems:
1. The frequency will change in the RX Control window, but the Mode will not update. I might start out with an AM station (eg 1060khz) and when I click on an FM station (eg 89.5Mhz) I still seem to have the AM Mode settings.
2. Sometimes the Main SP window will remain zoomed on a frequency, and there is no response when attempting to "unzoom" the display. The display seems well magnified.
3. Sometimes no matter what frequency I choose in the Memory Panel, the RX Control will not update.
I have tried installing the software as a normal user or Admin, and get the same results. And I have read through the documentation, but couldn't really find anything about "stuck" or non-responsive settings.
The only workaround seems to be either quit the app, or do a complete reset, but sometimes that doesn't work either.
Any help / comments / suggestions appreciated. Thank you!
I recently purchased an RSP2Pro, and have been very pleased with it so far. The software though has been a bit troublesome for me though, and I was wondering if someone can shed some light on what is going on with my setup.
I am using SDRUno V1.22 on a Win 10 laptop. The software boots just fine, and can initially get the SDR to work. However, I notice that when clicking on any of the frequencies in the Memory Panel, I experience a few problems:
1. The frequency will change in the RX Control window, but the Mode will not update. I might start out with an AM station (eg 1060khz) and when I click on an FM station (eg 89.5Mhz) I still seem to have the AM Mode settings.
2. Sometimes the Main SP window will remain zoomed on a frequency, and there is no response when attempting to "unzoom" the display. The display seems well magnified.
3. Sometimes no matter what frequency I choose in the Memory Panel, the RX Control will not update.
I have tried installing the software as a normal user or Admin, and get the same results. And I have read through the documentation, but couldn't really find anything about "stuck" or non-responsive settings.
The only workaround seems to be either quit the app, or do a complete reset, but sometimes that doesn't work either.
Any help / comments / suggestions appreciated. Thank you!