Omnirig and Ports.....the mystery "server"
Posted: Wed Jan 23, 2019 10:12 pm
Folks
I can not get my TS590SG to work both ways....though the manual (V1.23) boasts about OMNIRIG, Support Centre tells me they don't support 3rd party programs...OK...but the manual has 4 pages of stuff on the OMNIRIG and one wold assume someone knows something about the the way to go about this..oh well....
I must have tried 50 times in last 2 days to get this stuff to work both ways.....
So here are the basics and I would hope someone would jump in and help out.
(A) TS590SG is hard wired to a 232 port, COM2
(B) I have Uno avaialble, VSPE 64 bit/licensed, and DX Lab ready to assign the CAT port.
(C) DXlab runs just fine from COM2.
(D) Menu 69 in TS590 is set for USB
Since the Support Centre has declared the community needs to help out...HELP HELP
Need the info (1) thru (5) below
1) VSPE setup (split, pair..whatever makes it work)
2) Uno Setup (Main SETT>ORIG) and RX >SETT> CAT
3) I can handle the DX LAB side as one side is tied to the 232 over the TS590 and just need to assign the secondary CAT port
4 )RSYNCH! ready to activate (again)
5) OMNIRIG com callout (590 is in drop list)
The RSP1A pretty useless IMHO if it can't go back and forth (for hams)...RSP1A quite good for SWLs as thats quite straight forward
Tnx in advance
73
Jay
W2IJ
I can not get my TS590SG to work both ways....though the manual (V1.23) boasts about OMNIRIG, Support Centre tells me they don't support 3rd party programs...OK...but the manual has 4 pages of stuff on the OMNIRIG and one wold assume someone knows something about the the way to go about this..oh well....
I must have tried 50 times in last 2 days to get this stuff to work both ways.....
So here are the basics and I would hope someone would jump in and help out.
(A) TS590SG is hard wired to a 232 port, COM2
(B) I have Uno avaialble, VSPE 64 bit/licensed, and DX Lab ready to assign the CAT port.
(C) DXlab runs just fine from COM2.
(D) Menu 69 in TS590 is set for USB
Since the Support Centre has declared the community needs to help out...HELP HELP
Need the info (1) thru (5) below
1) VSPE setup (split, pair..whatever makes it work)
2) Uno Setup (Main SETT>ORIG) and RX >SETT> CAT
3) I can handle the DX LAB side as one side is tied to the 232 over the TS590 and just need to assign the secondary CAT port
4 )RSYNCH! ready to activate (again)
5) OMNIRIG com callout (590 is in drop list)
The RSP1A pretty useless IMHO if it can't go back and forth (for hams)...RSP1A quite good for SWLs as thats quite straight forward
Tnx in advance
73
Jay
W2IJ