Hi all
RSP on win10 (and XP)
saving a workspace saves the positions and modes but not the frequencies of the windows or the stations on VFOa or VFOb in all the windows!
Instead it brings the correct positions of all saved windows but with the frequency of VRX0 in all VRXs.
Can somebody enlighten me (ie tell me how to do it properly so I don't have to tune all opened widows again every time I run SdrUno?
Saving Workspace
-
josephlevy
- Posts: 1
- Joined: Thu Sep 22, 2016 11:31 am
Saving Workspace
Last edited by josephlevy on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Saving Workspace
The only frequency stored is the VRX#0 frequency. We will be addressing this in a future release.
Best regards,
SDrplay Support
Best regards,
SDrplay Support
Last edited by sdrplay on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Saving Workspace
It would also be useful if the modes & filters were stored too.The only frequency stored is the VRX#0 frequency. We will be addressing this in a future release.
Like VFO A "103.9 mhz" SWFM VFO B "145.725" NFM de emph or not etc
Last edited by g8ixn on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason