frequency jumps

Discussions about everything to do with SDRuno
Posts: 1
Joined: Mon Jan 02, 2017 2:02 pm

frequency jumps

Postby Conrad » Mon Jan 02, 2017 2:56 pm

My setup is an RSP2 using OmniRig and SDRUNO. It works very well except that with no notice the frequency jumps to 11.881 MHz. It is always the same jump to frequency and there is no time correlation or any form of input from me that would cause it. The event does not happen too often but enough to be irritating. I can easily re-tune to the original frequency but it will happen again.

Any ideas would be greatly appreciated

Last edited by Conrad on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Return to “SDRuno”

Who is online

Users browsing this forum: No registered users and 8 guests