Hi Z antenna port won't select on new RSP2

Discussions about everything to do with SDRuno
robpnelson
Posts: 1
Joined: Sat Jan 14, 2017 2:24 pm

Hi Z antenna port won't select on new RSP2

Postby robpnelson » Sat Jan 14, 2017 2:48 pm

I am having a problem setting up a new RSP2, using standard install of freshly downloaded SDRuno. PC is Windows 10. I am clicking around on the initial setup screen, and cannot select the HI Z port; I click on the button: and if the selected antenna was ANT A, no changes; if the selected antenna was ANT B, it switches to ANT A. I've tried this with the terminal block in and out of the device. Terminal block currently has 6 ft of hookup wire in the leftmost terminal, the other 2 with nothing.

Advice, please?
Last edited by robpnelson on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Tech_Support
Posts: 203
Joined: Mon Jun 01, 2015 7:00 pm

Re: Hi Z antenna port won't select on new RSP2

Postby Tech_Support » Sat Jan 14, 2017 3:11 pm

You can only select the Hi-Z port if your frequency is 30 MHz or below. Please check that you have set a frequency of less than 30 MHz before attempting to select the Hi-Z port.

Sincerely

SDRplay Tech_Support

Reason: No reason


Return to “SDRuno”

Who is online

Users browsing this forum: No registered users and 2 guests