SDRplay Community Forum

This forum is now suspended and will not accept any new posts or account registrations. For technical support relating to SDRplay hardware or software, please open up a support ticket via www.sdrplay.com/support
http://www.sdrplay.com/community/

Hi Z antenna port won't select on new RSP2

http://www.sdrplay.com/community/viewtopic.php?f=11&t=1818

Page 1 of 1

Hi Z antenna port won't select on new RSP2

Posted: Sat Jan 14, 2017 2:48 pm
by robpnelson
I am having a problem setting up a new RSP2, using standard install of freshly downloaded SDRuno. PC is Windows 10. I am clicking around on the initial setup screen, and cannot select the HI Z port; I click on the button: and if the selected antenna was ANT A, no changes; if the selected antenna was ANT B, it switches to ANT A. I've tried this with the terminal block in and out of the device. Terminal block currently has 6 ft of hookup wire in the leftmost terminal, the other 2 with nothing.

Advice, please?

Re: Hi Z antenna port won't select on new RSP2

Posted: Sat Jan 14, 2017 3:11 pm
by Tech_Support
You can only select the Hi-Z port if your frequency is 30 MHz or below. Please check that you have set a frequency of less than 30 MHz before attempting to select the Hi-Z port.

Sincerely

SDRplay Tech_Support
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/