Different Band on each receiver
Different Band on each receiver
Question is the RSP2 capable of listening to separate bands on each receiver at one time, I have only used mine for a few days but it seems that rec 2 and 3 are slaved to the primary receiver and I'm not able to choose a different band and on the 2nd and third receiver at the same time. I did notice that I can choose a different freq on each receiver but they have to remain within the band width and band I have chosen on receiver one. The reason I'm posting this is noticed on Ham Radio Outlets add that they show a screen shot of three receivers all on different bands so I'm assuming is can be done, Thanks in advance for the answer to what seems a dumb question I just assumed I could.
Last edited by rick40c on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Different Band on each receiver
Sure, with multipule RSP's. Yes the Virtual RX's are limited to within the 8-10mhz scope of the 1st RX.
Reason: No reason
Re: Different Band on each receiver
Thanks it Makes sense now I can vary with in the 8 to 10 MHz otherwise I need another RSP
Thanks,
Thanks,
Last edited by rick40c on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Different Band on each receiver
If you look carefully at the selected frequencies, they are all within a 10 MHz span.
Last edited by zardoz99 on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Different Band on each receiver
No the Add on the Ham Radio Outlets page which is also a link to a You Tube Post show three separate bands 160 meters 40 meters and 80 meters all running at the the same time so I just assumed I would be able to, but I'm clear on it now. What the add doesn't tell you is there running three separate receivers.
Thanks, AA5AX rick40c
Thanks, AA5AX rick40c
Last edited by rick40c on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Different Band on each receiver
Well, that is just 1.8 - 7.4 mhz so if the first rx was on the 80, with a 8mhz bw the vrx's could land on 160 and 40 mtr chunks. Yes?
Reason: No reason
Re: Different Band on each receiver
To cover those frequencies I would...
VRX0: Frequency = 4.6MHz Sample Rate = 6MHz (just leave VRX0 sitting there) - you can increase the sample rate if you need to see more spectrum.
VRX1: Frequency = 1.8MHz
VRX2: Frequency = 7.4MHz
Then just use VRX1 and VRX2 to view each band (make sure they are enabled)
Best regards,
SDRplay Support
VRX0: Frequency = 4.6MHz Sample Rate = 6MHz (just leave VRX0 sitting there) - you can increase the sample rate if you need to see more spectrum.
VRX1: Frequency = 1.8MHz
VRX2: Frequency = 7.4MHz
Then just use VRX1 and VRX2 to view each band (make sure they are enabled)
Best regards,
SDRplay Support
Reason: No reason