How to Enter 1090mhz
How to Enter 1090mhz
What is the proper key entry for the ADS-B frequency of 1090 MHz...I keep getting weird results! Thanks,
Steve
Steve
Last edited by KA1OWC on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Steve Ziegler
KA1OWC
Lieutenant Colonel (Ret)
United States Army
KA1OWC
Lieutenant Colonel (Ret)
United States Army
Re: How to Enter 1090mhz
Just remember that SDRUno uses KHz entry, so add three zeros on the end. I wish they'd make it MHz or KHz, and give us a key for each. My Signal Hound analyser does this - I just type 105 k or 220 m and it takes me there.
Reason: No reason
Andy
Re: How to Enter 1090mhz
Really having problems now...Maybe I'm just slow, but this entry stuff confuses me...
How should the screen look for: 1090 MHz 146.910
Is the attached screen shot what I should have for the ADS-B aviation frequency?
Thanks for your patience!
How should the screen look for: 1090 MHz 146.910
Is the attached screen shot what I should have for the ADS-B aviation frequency?
Thanks for your patience!
- Attachments
-
- Ashampoo_Snap_2017.05.18_15h00m09s_002_.jpg (9.11 KiB) Viewed 10930 times
Last edited by KA1OWC on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Steve Ziegler
KA1OWC
Lieutenant Colonel (Ret)
United States Army
KA1OWC
Lieutenant Colonel (Ret)
United States Army
Re: How to Enter 1090mhz
That's correct. You should be tuned to 1090 MHz.
For 146.910 MHz, enter 146910 without any decimal points.
It is quite confusing, as you enter in KHz but the software puts in decimal points and makes you think you've done it wrong. Please people at SDR Play, give us MHz/KHz keys!
Good luck!
For 146.910 MHz, enter 146910 without any decimal points.
It is quite confusing, as you enter in KHz but the software puts in decimal points and makes you think you've done it wrong. Please people at SDR Play, give us MHz/KHz keys!
Good luck!
Reason: No reason
Andy