Startup Error - Device doesn't Exist or is Open

[n3hkn]

RSP1A, Windows 10, Yaesu FT-450D

I am getting this error every time I open SDRuno. However, I can use DXLabs Commander and the program immediately recognizes the radio, displays the frequency and allows common adjustment. While I can ignore the error and continue SDRuno does not see the radio and no interaction is possible.

If I click OK to the "not available" message I then see on the RX Control box Sett that I can't get connected to the radio.

Main Sett shows Connected to OmniRig server. Just as a precaution I updated to the latest Rig's list/folder.

Dick N3HKN

[n3hkn]

Addendum - SDRuno is now working with the FT-450D. It may have been working for awhile but I was focused on the error message.

RX Control/Settings shows Status: Not Connected BUT the process is working.

Dick N3HKN