SDRUno selected tuner/port startup bug with RSPDuo?
Posted: Sun Aug 26, 2018 10:37 am
I have my RSPDuo set up with a whip antenna connected to the 50 ohm port on Tuner 1, and a long wire antenna connected through a 9:1 balun connected to the 50 ohm port on Tuner 2.
When SDRUno starts, the UI indicates that the Tuner 2 50 ohm port is selected (the state that it was in when SDRUno was running last time). When I click Play, the signal level and the HF band I was expecting to see are not there.
If I click the 50 ohm port on Tuner 1 and then click on the 50 ohm port for Tuner 2 (taking me back to where I started), the waterfall suddenly starts showing the band and the signals I was expecting, and everything is fine from then on.
I'm using the latest SDRUno and driver V1.24 from 24th August 2018
Mark
When SDRUno starts, the UI indicates that the Tuner 2 50 ohm port is selected (the state that it was in when SDRUno was running last time). When I click Play, the signal level and the HF band I was expecting to see are not there.
If I click the 50 ohm port on Tuner 1 and then click on the 50 ohm port for Tuner 2 (taking me back to where I started), the waterfall suddenly starts showing the band and the signals I was expecting, and everything is fine from then on.
I'm using the latest SDRUno and driver V1.24 from 24th August 2018
Mark