Rig Control Delay - IC7300

Discussions about everything to do with SDRuno
n3hkn
Posts: 18
Joined: Sat Jan 27, 2018 7:17 pm

Rig Control Delay - IC7300

Postby n3hkn » Wed Sep 19, 2018 2:45 pm

I am using SDRuno/RSP1A as a panadaptor for an Icom 7300. Works well except - there is a few second delay between clicking/selecting a signal on the SDRuno display and a reaction by the 7300. I have tried several speeds between the PC and the 7300 but basically the problem remains. If I quickly use the mouse roller to change frequency SDRuno slowly steps the 7300 through all of the intervening frequencies eventually arriving at the chosen frequency. Not a disaster but could be better.
Dick N3HKN
:?:

Reason: No reason

DK7OB
Posts: 74
Joined: Thu Mar 24, 2016 7:14 am

Re: Rig Control Delay - IC7300

Postby DK7OB » Sat Sep 22, 2018 7:03 am

Do you have bidirectional synchronization enabled (so if you change the frequency on the 7300, SDRUno would follow)? I see the same problem with an old FT990 at our club station but did not investigate it yet. If I configure the unidirectional synchronization SDRUno -> FT 990, the TRX follows SDRUno without delay.

Reason: No reason


Return to “SDRuno”

Who is online

Users browsing this forum: No registered users and 1 guest