RSPDuo and SDRUNO 1.24
Posted: Fri Dec 14, 2018 9:37 pm
Having (almost) "cut my teeth on the excellent RSP2," I have now set up an RSPduo, dowloaded and insalled the software (very familiar with the process) and have run it very successfully in Single Tuner mode.
I have previously not used a Master/Slave configuration, but have run into a couple of problems.
The pre-designed default configuration loads and functions perfectly. However, having selected this tuner as master and used the optional auto-arrange master layout for this tuner (which comes up as a bit of a mess - absolutely not as advertised) and activated activated a second intance (the second tuner), the main panel for this does not load, although the RX panel does when selected, along with the SP1 & 2 panels, so I'm rather stumped at the moment.
I have gone through a couple of resets and programme uninstals/reloads several times with no change to this.
Does anyone have any advice or a olution please?
I have previously not used a Master/Slave configuration, but have run into a couple of problems.
The pre-designed default configuration loads and functions perfectly. However, having selected this tuner as master and used the optional auto-arrange master layout for this tuner (which comes up as a bit of a mess - absolutely not as advertised) and activated activated a second intance (the second tuner), the main panel for this does not load, although the RX panel does when selected, along with the SP1 & 2 panels, so I'm rather stumped at the moment.
I have gone through a couple of resets and programme uninstals/reloads several times with no change to this.
Does anyone have any advice or a olution please?