Page 1 of 1
Changes in scanner very annoying with new 1.31
Posted: Sat Apr 13, 2019 6:18 am
by sdrom33
Now when scanner is on many controls don't work. If I get signal with volume too low or too high I must switch off, set the volume while I do not hear nothing then switch on again. If I wish to set the squelch I must switch off and set it by ear because I not hear the noise. All this very annoying & difficult. Perhaps previous version was better why change.
Re: Changes in scanner very annoying with new 1.31
Posted: Sun Apr 14, 2019 6:46 am
by Paul
If you observe the scanner pane you will see that full functionality of SDRuno is restored when you "STOP" the scanner - not when "PAUSED."
You do NOT have to switch off the scanner - just select "STOP," then resume scan.
I hope that this may help.
Re: Changes in scanner very annoying with new 1.31
Posted: Sun Apr 14, 2019 4:29 pm
by sdrom33
Thanks Paul, very good, I had overlooked this & compliments to SDRuno staff, sometimes we do not appreciate their work!