sdruno and elecraft k3 I.F. output and WINDOWS 10
sdruno and elecraft k3 I.F. output and WINDOWS 10
Hello,
thanks for read this message.
Have found this new sdruno software.
Is possible use this with Elecraft k3 same panadapter ?
I use creative EMU 1616M , but sdruno need extio.dll.
The program run well with WMME 16 bit drivers, but not with ASIO 24 bit
There is some config for use the ASIO drivers ?
Best regards from ic8fax in Capri Island
Jacob
thanks for read this message.
Have found this new sdruno software.
Is possible use this with Elecraft k3 same panadapter ?
I use creative EMU 1616M , but sdruno need extio.dll.
The program run well with WMME 16 bit drivers, but not with ASIO 24 bit
There is some config for use the ASIO drivers ?
Best regards from ic8fax in Capri Island
Jacob
Last edited by ic8fax on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason