HDSDRplay version 2.75 Beta3

General discussions
Robert
Posts: 1
Joined: Sat Jan 21, 2017 8:39 pm

HDSDRplay version 2.75 Beta3

Postby Robert » Sat Jan 21, 2017 8:57 pm

I am currently using the RSP2Pro device along with the HDSRplay2 software. I am fairly new to this SDR set up and I am hoping that someone can point me in the right direction when using the software mentioned above. When I open up the Frequency Manager and I open up the two meter band, I am able to see the band scope showing the different frequencies in use on the two meter band. The problem is even though I have the selector in the FM position, I only hear static even when I am on top of a received signal. I have tried a variety of different switch combinations but I sill am not able to hear the proper audio of any received signal. I am sure that I am doing something wrong somewhere but why can't I hear the FM signals in the two meter band. Anyone have any ideas? Any suggestions would be appreciated. Thanks Bob
Last edited by Robert on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Return to “General”

Who is online

Users browsing this forum: No registered users and 3 guests