Sdrplay for Seti project.
Posted: Wed Feb 01, 2017 3:02 pm
Hi, i am a radioham and i like to use the sdrplay.
I am used to the HDSDR program with the sdrplay.
But i want to have something else:
I like to connect the sdrplay via usb to a windows computer
and than i like to scan a specific frequency trajectory continuously.
for example 550.0 to 550.5 MHz.
i like to get the output of an FFT calculation over this frequency traject
in a file. So every FFT calculation gives a file whith frequency and strength
of the received signal.
After this my own written programs will do things with this files.
I do write programs in Pure Basic.
i do'nt need any graphic visualisation, i just need a black box program which
delivers a stream of files. (eventualy i can give some paramters to it)
So i think this must be possible whith the sdrplay, but i am definitively not
capable of writing this progam.
( i do need this for a Seti receiving setup with a huge antenna array system.)
So can anybody help me please ?
Wim PA0SLT
I am used to the HDSDR program with the sdrplay.
But i want to have something else:
I like to connect the sdrplay via usb to a windows computer
and than i like to scan a specific frequency trajectory continuously.
for example 550.0 to 550.5 MHz.
i like to get the output of an FFT calculation over this frequency traject
in a file. So every FFT calculation gives a file whith frequency and strength
of the received signal.
After this my own written programs will do things with this files.
I do write programs in Pure Basic.
i do'nt need any graphic visualisation, i just need a black box program which
delivers a stream of files. (eventualy i can give some paramters to it)
So i think this must be possible whith the sdrplay, but i am definitively not
capable of writing this progam.
( i do need this for a Seti receiving setup with a huge antenna array system.)
So can anybody help me please ?
Wim PA0SLT