Kenwood 990s with SDRplay 2- need help with interface

General discussions
Post Reply
dustywoodlief
Posts: 1
Joined: Sat Nov 25, 2017 2:10 pm

Kenwood 990s with SDRplay 2- need help with interface

Post by dustywoodlief » Sat Nov 25, 2017 2:19 pm

Can someone assist me with interfacing a SDRplay 2 with a Kenwood 990s ? Want to use the same antenna and use as a panadapter.

I use it with my 590SG (DRV) , however the 990s is different.

Has anyone done it with the Kenwood 990S .
Last edited by dustywoodlief on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

User avatar
N7XRD
Posts: 6
Joined: Sat Nov 25, 2017 11:25 am

Re: Kenwood 990s with SDRplay 2- need help with interface

Post by N7XRD » Sat Nov 25, 2017 4:21 pm

There is a tried and tested way to do this in the TS-990S yahoo groups page I'm told.
Last edited by N7XRD on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

User avatar
Harry
Posts: 36
Joined: Mon Nov 02, 2015 9:47 pm

Re: Kenwood 990s with SDRplay 2- need help with interface

Post by Harry » Sat Nov 25, 2017 4:56 pm

It' relatively easy. The simplest way is to plug a "Y" cable into the RX IN and RX OUT jacks on the back of the rig, connect it to the SDRplay and then press the RX ANT button on the front panel.


I've been using an SDRplay with my TS-990 for a few years. Works relatively well.

Harry WE1X

Reason: No reason

Post Reply