Just Brought a SDR 2 - Need some advice
-
- Posts: 1
- Joined: Sun Jan 21, 2018 4:29 am
Just Brought a SDR 2 - Need some advice
Hey everyone - just brought a SDR 2 from Strictly Ham (Melbourne Australia)...need some advice
- whats the best computer setup do you need to run this baby...planning on upgrading my computer - was looking at a HP all in one - whats ya thoughts?
- got a Diamond Discone for the general scanning - do I need any other types etc?
- is there CTCSS available
- does it decode POCSAG?
Thanks Jon
- whats the best computer setup do you need to run this baby...planning on upgrading my computer - was looking at a HP all in one - whats ya thoughts?
- got a Diamond Discone for the general scanning - do I need any other types etc?
- is there CTCSS available
- does it decode POCSAG?
Thanks Jon
Last edited by Aussie Deesal on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Just Brought a SDR 2 - Need some advice
Hi Jon.
I find SDRUno runs fine on my shack laptop, which is an i5/2.4 Ghz/4 GB machine. However, I don't use more than one VRX at a time and I never use a b/w of more than 8 MHz. I think you'll need a more powerful machine if you want to use full b/w and multiple VRX's.
I can even run it on my old Pentium 6200 laptop, but I have to stay below 5 MHx b/w and make sure all other apps are closed.
Aerials - it depends what you want to listen to. I use a Wellbrook 1530 loop for LF to 30 MHz and a selection of dipoles and yagis for VHF/UHF.
As for POCSAG and other digital modes, the RSP's do not natively decode anything, but they can be used with add-on software to decode all manner of stuff. Lots of advice over on the facebook group.
CTCSS is not included, it just hears everything and ignores the tones.
I find SDRUno runs fine on my shack laptop, which is an i5/2.4 Ghz/4 GB machine. However, I don't use more than one VRX at a time and I never use a b/w of more than 8 MHz. I think you'll need a more powerful machine if you want to use full b/w and multiple VRX's.
I can even run it on my old Pentium 6200 laptop, but I have to stay below 5 MHx b/w and make sure all other apps are closed.
Aerials - it depends what you want to listen to. I use a Wellbrook 1530 loop for LF to 30 MHz and a selection of dipoles and yagis for VHF/UHF.
As for POCSAG and other digital modes, the RSP's do not natively decode anything, but they can be used with add-on software to decode all manner of stuff. Lots of advice over on the facebook group.
CTCSS is not included, it just hears everything and ignores the tones.
Reason: No reason
Andy