SDRplay Community Forum

This forum is now suspended and will not accept any new posts or account registrations. For technical support relating to SDRplay hardware or software, please open up a support ticket via www.sdrplay.com/support
http://www.sdrplay.com/community/

sdr-console, no audio output on cw

http://www.sdrplay.com/community/viewtopic.php?f=5&t=717

Page 1 of 1

sdr-console, no audio output on cw

Posted: Fri May 06, 2016 9:37 pm
by g6trm
Hi,
Just getting started with the sdrplay and have found sdr-console seems to work best on my laptop. If I monitor broadcast fm or VHF ham frequencies, audio is no problem. However selecting cw and monitoring a radio beacon, nothing is heard but I can see the cw signal clearly on the waterfall.
Am I doing something wrong?

regards

Mike

Re: sdr-console, no audio output on cw

Posted: Sat May 07, 2016 12:31 am
by g1hbe
This is one of the reasons I gave up on Console. Everything an be going fine, then you start looking at weak signals and...no audio. It is something that has plagued Console from the earlier versions. The other main reason is that I find Console over complex and difficult to 'drive'. I'll stick to HDSDR and SDR Sharp for now (I still have v.1361 installed).

Re: sdr-console, no audio output on cw

Posted: Tue May 10, 2016 8:39 pm
by NN4F
Mike, can you do a screen shot when you are tuned to the CW signal, could be a cw bandwidth issue? Also make sure you have the autonotch turned off when in CW...

Paul - NN4F
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/