GNUradio

General discussions
Forum rules
Post Reply
signon
Posts: 3
Joined: Fri Jul 15, 2016 9:17 pm

GNUradio

Post by signon » Fri Jul 15, 2016 9:24 pm

Hi everyone,

Can you tell me how can I pass some parameters to my SDR in GNUradio by command line? Parameters like frequency, if the gain is manual or not, etc...


Thanks a lot,

SIGNON
Last edited by signon on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Top
sdrplay
Posts: 978
Joined: Wed Jan 07, 2015 7:58 am

Re: GNUradio

Post by sdrplay » Sat Jul 16, 2016 7:11 am

I don't think so. Gnu Radio is a modular system where you place blocks for sources, etc. - you specify the parameters in the source as values or variables that you can set from elsewhere in your function.

Best regards,

SDRplay Support
Last edited by sdrplay on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Top
signon
Posts: 3
Joined: Fri Jul 15, 2016 9:17 pm

Re: GNUradio

Post by signon » Sat Jul 16, 2016 11:37 am

is there any possible way to change those parameters without a graphical interface?


Best regards,
SIGNON
Last edited by signon on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Top
Post Reply

Return to “General”