Page 1 of 1
Sdrsharp pluggin
Posted: Fri Jan 13, 2017 12:52 pm
by kevtheskin
Hi everyone,
I am trying to install the Sdrsharp plugin version2.2. It keeps bring up an error setup has detected a problem with this Sdrsharp install.
Any ideas.
Cheers Kev
Re: Sdrsharp pluggin
Posted: Tue Jan 17, 2017 8:26 am
by sdrplay
During the install of the plugin, it will require you to navigate to your SDR# installation directory and select the SDRSharp.exe before continuing.
Please note that this is only for SDR# version greater than 1411 and will only provide basic tuning for the RSP1. The RSP2 is not supported. You will also need an old version of the API which you can get here if you don't have it:
http://www.sdrplay.com/software/MiricsS ... r_1.97.exe
Best regards,
SDRplay Support
Re: Sdrsharp pluggin
Posted: Tue Jan 17, 2017 7:59 pm
by JMG
Works fine with SDRsharper(v0.5k) too.
Re: Sdrsharp pluggin
Posted: Wed Jan 18, 2017 10:09 am
by ic706mk2
Hey,
@Jmg..
Don't work by me..what did you do..only the old api or must we do something else also?
Change the Sharper.exe to Sharp.exe???
SDRSharp much better to works with .
Greetings
Luc
Re: Sdrsharp pluggin
Posted: Tue May 09, 2017 11:23 pm
by supwiddiss
New to this. A day into my RSP2pro. Due to the amount of plugins for # it was my assumption that the RSP2 would be a breeze to get working with it.
No Joy!
HDSDR and SDRConsole seem limited for plugins also, Hence it looks like I have a simple radio receiver and need to use VAC/VB Cable to pipe into the other applications that I accepted would seamlessly work with the RSP2.
Any and all comments are welcome. I am an EE with tons of years using HAM equipment and anything electronic that is fun.
Cheers.