Page 1 of 1
dump1090 / RSP2
Posted: Thu Jun 01, 2017 1:25 pm
by zardoz99
I've had a look around for the answer to this but failed.
Why does dump1090 only support the Port B only?
Does it automatically enable bias-t?
Re: dump1090 / RSP2
Posted: Fri Jun 02, 2017 6:53 pm
by zardoz99
Looks like the bias-t answer is no. A simple voltmeter test confirmed that. I'm trying out the coaxial colinear with a termination resistor, so didn't want to effectively short out the bias-t supply.
Re: dump1090 / RSP2
Posted: Sun Aug 13, 2017 8:01 pm
by EA3HUF
There is an option to use portA.
You can check it doing
on the command prompt.
The option is
You can add the option to the .cmd file you use to start dump1090
Re: dump1090 / RSP2
Posted: Sun Aug 13, 2017 8:03 pm
by EA3HUF
Sorry, I forgot, there is also an option to enable BiasT. So I assume it is not activated by default (try --help)