SDRplay RSP 2 has ceased operating properly on MAC/CUBICSDR

Post information or questions regarding SDRplay products here
Post Reply
newmediajim
Posts: 2
Joined: Sat Jan 06, 2018 10:43 pm

SDRplay RSP 2 has ceased operating properly on MAC/CUBICSDR

Post by newmediajim » Sat Jan 06, 2018 11:14 pm

Today I connected a short wire antenna using the Hi-Z port to listen to some HF. Everything was operating properly, until later in the day I re-launched CubicSDR.

The software "sees" the SDRplay, but CubicSDR doesn't show a waterfall and there is now audio. My computer is also recognizing the device in the system report. Unsure if this is noteworthy or not. I'm not able to "hide" the CubicSDR application on my desktop.

So far, I have re-seated the usb connection and I've re-installed the API/HW drivers and Cubic SDR. I'm attempting to attach screen grabs.
Screen Shot 2018-01-06 at 5.57.21 PM.png
Screen Shot 2018-01-06 at 5.57.21 PM.png (202.01 KiB) Viewed 8497 times
Screen Shot 2018-01-06 at 5.48.46 PM.jpg
Screen Shot 2018-01-06 at 5.48.46 PM.jpg (199.76 KiB) Viewed 8497 times
Screen Shot 2018-01-06 at 5.49.49 PM.jpg
Screen Shot 2018-01-06 at 5.49.49 PM.jpg (197.53 KiB) Viewed 8497 times

Thanks for any ideas and help!
Last edited by newmediajim on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

sdrplay
Posts: 978
Joined: Wed Jan 07, 2015 7:58 am

Re: SDRplay RSP 2 has ceased operating properly on MAC/CUBICSDR

Post by sdrplay » Sun Jan 07, 2018 1:24 pm

Set RF gain reduction (RFGR) to 0 - depending on the frequency, 8 is probably out of bounds.

If you are still having problems, come through to Support (https://www.sdrplay.com/support)

Best regards,

SDRplay Support

Reason: No reason

newmediajim
Posts: 2
Joined: Sat Jan 06, 2018 10:43 pm

Re: SDRplay RSP 2 has ceased operating properly on MAC/CUBICSDR

Post by newmediajim » Sun Jan 07, 2018 8:49 pm

thank you. After a couple of computer re-starts, I re-seated the USB at the SDRplay. Suddenly it worked :?: :D
Last edited by newmediajim on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Post Reply