SkimmerServer and RSPDuo - crash when changing config
SkimmerServer and RSPDuo - crash when changing config
Hi all - support - Steve,
I have an issue with CW Skimmer Server:
* When doing and confirming (Apply or OK) any change in Skimmer, Telnet and/or Operator Tab the SkimSrvr stop running and close (even when clicking APPLY without having done any change)
My setup:
SDRplay DUO
CW Skimmer Server:
* Skimmer Server V1.6
* SDRplayintf.dll (V1.3) installed in the same directory
* Win 10 o/s
Initial status:
* The Server run and start monitoring the first band.
* Status is OK (Telnet Server OK and SDR Receiver OK)
* Segment at start 7, 14, 21 MHz
* Band rotation ok after 2 mins
Is this a limitation in the SDRplayintf.dll that does not allow changes in the setting file?
Ho can I diagnose?
SkimSrv TelnetServer log just report:
- Starting server on port 7300
- server started
Thanks, 73
Alessandro i2sva
I have an issue with CW Skimmer Server:
* When doing and confirming (Apply or OK) any change in Skimmer, Telnet and/or Operator Tab the SkimSrvr stop running and close (even when clicking APPLY without having done any change)
My setup:
SDRplay DUO
CW Skimmer Server:
* Skimmer Server V1.6
* SDRplayintf.dll (V1.3) installed in the same directory
* Win 10 o/s
Initial status:
* The Server run and start monitoring the first band.
* Status is OK (Telnet Server OK and SDR Receiver OK)
* Segment at start 7, 14, 21 MHz
* Band rotation ok after 2 mins
Is this a limitation in the SDRplayintf.dll that does not allow changes in the setting file?
Ho can I diagnose?
SkimSrv TelnetServer log just report:
- Starting server on port 7300
- server started
Thanks, 73
Alessandro i2sva
Reason: No reason
Re: SkimmerServer and RSPDuo - crash when changing config
Issue solved with the latest release of
SDRplayintf.dll V1.5
Thanks to Steve, N2IC for the new development!
73
Alessandro i2sva
SDRplayintf.dll V1.5
Thanks to Steve, N2IC for the new development!
73
Alessandro i2sva
Reason: No reason