https://ansi.23-5.eu/2018/01/sdrplay-re ... omment-482
Only failings of that Tutorial is that at one point tit leaves the newbie stranded.
but it gives you no Code to type to tell you how to do that...Binary Libraries
The driver can be downloaded from the SDRplay homepage https://www.sdrplay.com/rpi2dl.php
I knew how to create a SMB share on the Pi, so what I did was download the file mentioned in the link to my Mac, then find the Pi on the Network and drag it over the network
Alos once you have completed each of the 'steps' of code, you get 'dumped' back at the command Prompt, in the new directory...
In order to start the next 'bloc' of code you need to use the command to go back up the directory to the Home/pi/ folder.
If you do not do that you end up in a hell of a mess and nothing works and the only way out for a newbie is to re-burn the Micro SD card and start again. So use "cd .." a few times until you are at /home/pi/ before starting the next batch of code.
Also , there is no instructions on how to get the server to run automatically on re boot
Code: Select all
sudo systemctl enable SoapySDRServer