Raspberry Pi 3 + SDRplay for ADS-B
Posted: Wed Jun 01, 2016 5:39 pm
My brother bought me a SDRPlay on Dayton Hamvention 2016.
My current setup is a RTL-SDR dongle + LNA with Raspberry Pi 3 for ADB-S with dump1090 can copy up to 200 nmi.
Today, I turn off my main ADB-S setup and connected the ADS-B external antenna to a Backup RPI3 with the SDRPlay (with no LNA).
I follow the instructions and installed OK the installer software.
Then run the command:
sdrplay_dump1090 --dev-sdrplay --net --oversample
After more than 2 hours can only copy planes up to 15 nm and only few messages. Then tried without the --oversample and still the same results.
Has anyone tried the SDRPlay with a Raspberry Pi 2/3 and the current Raspberry Pi installer with good results?
My current setup is a RTL-SDR dongle + LNA with Raspberry Pi 3 for ADB-S with dump1090 can copy up to 200 nmi.
Today, I turn off my main ADB-S setup and connected the ADS-B external antenna to a Backup RPI3 with the SDRPlay (with no LNA).
I follow the instructions and installed OK the installer software.
Then run the command:
sdrplay_dump1090 --dev-sdrplay --net --oversample
After more than 2 hours can only copy planes up to 15 nm and only few messages. Then tried without the --oversample and still the same results.
Has anyone tried the SDRPlay with a Raspberry Pi 2/3 and the current Raspberry Pi installer with good results?