Coupling strategy test HF CENELEC B in a AC line
Posted: Wed Dec 05, 2018 7:00 pm
Hi,
What would be the strategy to couple the High Impedance port of the SRDDuo to test CENELEC B (25 - 95 Khz) Data over single pole AC (125 V) circuit
I though of a resistor division of 10MOhm and 1MOhm to ground and then place a second divisor of 1KOhm 100 Ohm at the 1MOhm resistor connected to P and N-G to ground - I still believe is too high, but first looking for others
Thanks
E
What would be the strategy to couple the High Impedance port of the SRDDuo to test CENELEC B (25 - 95 Khz) Data over single pole AC (125 V) circuit
I though of a resistor division of 10MOhm and 1MOhm to ground and then place a second divisor of 1KOhm 100 Ohm at the 1MOhm resistor connected to P and N-G to ground - I still believe is too high, but first looking for others
Thanks
E