Sample Rate to 3-4-5- ..... Mhz

Discussions about everything to do with SDRuno
Post Reply
pc2c-Rene
Posts: 5
Joined: Sat May 13, 2017 4:19 pm

Sample Rate to 3-4-5- ..... Mhz

Post by pc2c-Rene » Mon May 21, 2018 3:50 pm

Since I used my SDRplay as a pan adapter for my FTdx5000 I can not set the Sample Rate to 3-4-5- etc. Mhz anymore.
Only 2 and 8,192 can I select.
What have I forgotten?
Image
Last edited by pc2c-Rene on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Tech_Support
Posts: 499
Joined: Mon Jun 01, 2015 7:00 pm

Re: Sample Rate to 3-4-5- ..... Mhz

Post by Tech_Support » Mon May 21, 2018 4:29 pm

Hello,
This is because you have put your device in low IF mode and in Low IF mode, these are the only sample rates available. Open up the Settings Panel (SETT button on the main panel) and select Zero IF mode and you will be able to set up to 10 MHz sample rate again.

Sincerely

SDRplay Tech_Support

Reason: No reason

pc2c-Rene
Posts: 5
Joined: Sat May 13, 2017 4:19 pm

Re: Sample Rate to 3-4-5- ..... Mhz

Post by pc2c-Rene » Mon May 21, 2018 8:12 pm

What can life be easy if you are getting a little help. :D
Thanks for the quick reply.
Last edited by pc2c-Rene on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Post Reply