HDSDR sample rate not working
HDSDR sample rate not working
When I change the sample rate in the device controller, it does not work for anything other than 2 MHz.
It doesn't matter what setting I choose, only 2 MHz of bandwidth are displayed on the screen.
In the screenshots below, both HDSDR and SDRuno are running at 10 MHz sample rate, but HDSDR only shows 2 MHz.
Does anybody know why this is happening? What settings am I messing up?
It doesn't matter what setting I choose, only 2 MHz of bandwidth are displayed on the screen.
In the screenshots below, both HDSDR and SDRuno are running at 10 MHz sample rate, but HDSDR only shows 2 MHz.
Does anybody know why this is happening? What settings am I messing up?
Last edited by ugallu on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: HDSDR sample rate not working
The sample rate is 10 MHz, but the IF bandwidth is only 1.536 MHz - if you change that to 8 MHz, then you will see the full spectrum width.
Best regards,
SDRplay Support
Best regards,
SDRplay Support
Reason: No reason
Re: HDSDR sample rate not working
That fixed my problem. Thanks a lot.sdrplay wrote:The sample rate is 10 MHz, but the IF bandwidth is only 1.536 MHz - if you change that to 8 MHz, then you will see the full spectrum width.
Last edited by ugallu on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason