SDRuno CAT menu
SDRuno CAT menu
I have Omnirig set up beautifully with 2-way communication between Uno and the Knwd 870. All is good and I am a happy camper.
But if I go to RX Control Panel and the CAT menu, I can't seem to get a Connect.
Even after reading the manual, I have questions...
1) Do I NEED to have this CAT feature enabled? Apparently I don't since Omnirig seems to be doing its thing.
2) What is the design purpose of this CAT feature if all appears to be handled by Omnirig?
But if I go to RX Control Panel and the CAT menu, I can't seem to get a Connect.
Even after reading the manual, I have questions...
1) Do I NEED to have this CAT feature enabled? Apparently I don't since Omnirig seems to be doing its thing.
2) What is the design purpose of this CAT feature if all appears to be handled by Omnirig?
Last edited by VE9DAN on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: SDRuno CAT menu
Omni-Rig for communication between SDRuno and your transceiver.
CAT is to make SDRuno behave like a transceiver (Kenwood TS-480)
Best regards,
SDRplay Support
CAT is to make SDRuno behave like a transceiver (Kenwood TS-480)
Best regards,
SDRplay Support
Reason: No reason