RSP2pro + Leo Bodnar GPS not working

General discussions
Post Reply
Ed Erlemann
Posts: 1
Joined: Fri Apr 26, 2019 11:46 am

RSP2pro + Leo Bodnar GPS not working

Post by Ed Erlemann » Fri Apr 26, 2019 12:07 pm

Hello,
I have Leo Bodnar GPSDO (2 ports) one port I use for 10MHz reference to SG-Lab Transverter, the other port I set to 24MHz.
Trying to feed 24MHz first to SDRPlay RSP2pro then use the output to feed same 24MHz to the LNB used to rx QO-100 SAT, but it seems the output reference from RSP2 does not work? The picture shows a RSP1 but I am using a RSP2pro. I tried also removing the 50 Ohm load from the T bnc connector and connect the cable going to the LNB but doing this RSP2 will not even be recognized by the pc usb.

Please any advise on how to solution this problem?

Thanks

Ed Erlemann
Attachments
RSP2_GPSDO.JPG
RSP2_GPSDO.JPG (53.31 KiB) Viewed 10904 times
Last edited by Ed Erlemann on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Tech_Support
Posts: 499
Joined: Mon Jun 01, 2015 7:00 pm

Re: RSP2pro + Leo Bodnar GPS not working

Post by Tech_Support » Fri Apr 26, 2019 1:38 pm

Hello Ed,
Please read the following application note on using an external clock source with the RSP2.

https://www.sdrplay.com/docs/SDRplay_RS ... e_R1P0.pdf

Sincerely

Tech_Support

Reason: No reason

Post Reply