Centering panadapter display

Discussions about everything to do with SDRuno
Post Reply
N3ZP
Posts: 3
Joined: Mon Dec 19, 2016 6:14 pm

Centering panadapter display

Post by N3ZP » Tue Dec 27, 2016 2:31 pm

I am just getting familiar with my new RSP2 running SDRuno. When I select a signal in the panadapter display the receiver moves to the signal. If I get near either end of the display I would like to re-center the display to look at other signals in that part of the band. Is there a way to center the display on the last select signal?

Thanks,

Phil N3ZP
Last edited by N3ZP on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Tod Yampel
Posts: 7
Joined: Mon Dec 26, 2016 3:34 pm

Re: Centering panadapter display

Post by Tod Yampel » Tue Dec 27, 2016 7:18 pm

Try the button on the bottom of the SP1 screen.
It is to the right of the zoom buttons.

Good luck.

73 KD2JNF
Last edited by Tod Yampel on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

KE2KB
Posts: 30
Joined: Fri Dec 02, 2016 1:11 am

Re: Centering panadapter display

Post by KE2KB » Wed Dec 28, 2016 4:12 am

Strangely, or not, you meed to be zoomed to at least one level before the "vfo" button will work to center your display.

Reason: No reason

N3ZP
Posts: 3
Joined: Mon Dec 19, 2016 6:14 pm

Re: Centering panadapter display

Post by N3ZP » Wed Dec 28, 2016 10:08 pm

Thanks, that did the trick.

Phil N3ZP
Last edited by N3ZP on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Post Reply