Hi Z antenna port won't select on new RSP2
-
- Posts: 1
- Joined: Sat Jan 14, 2017 2:24 pm
Hi Z antenna port won't select on new RSP2
I am having a problem setting up a new RSP2, using standard install of freshly downloaded SDRuno. PC is Windows 10. I am clicking around on the initial setup screen, and cannot select the HI Z port; I click on the button: and if the selected antenna was ANT A, no changes; if the selected antenna was ANT B, it switches to ANT A. I've tried this with the terminal block in and out of the device. Terminal block currently has 6 ft of hookup wire in the leftmost terminal, the other 2 with nothing.
Advice, please?
Advice, please?
Last edited by robpnelson on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
-
- Posts: 499
- Joined: Mon Jun 01, 2015 7:00 pm
Re: Hi Z antenna port won't select on new RSP2
You can only select the Hi-Z port if your frequency is 30 MHz or below. Please check that you have set a frequency of less than 30 MHz before attempting to select the Hi-Z port.
Sincerely
SDRplay Tech_Support
Sincerely
SDRplay Tech_Support
Reason: No reason