SDR-Console support for RSP2

General discussions
Posts: 1
Joined: Sun Jan 15, 2017 2:40 pm

SDR-Console support for RSP2

Postby bagmouse7 » Sun Jan 15, 2017 3:24 pm

I have been a long time fan of SDR-Console v2 and it is my go to program for most SDR use.
Now that I have a couple of days use of SDR-Console v3 and the RSP2 combo, I am happy to report that it is also working very well.
I am using the Hi-Z port with a 20 meter vertical wire antenna.
I expected good VHF-UHF performance with the RSP2, but I am also an avid HF listener and I normally use dedicated HF radios for listening.
The results so far are really good with the RSP2 on HF.
Attached is a screenshot on SDRv2 on top and SDRv3 with RSP2 on bottom on the 80 meter band last night.

A couple of things I found I need to do for best performance HF.
USB cable was critical for low noise. When I first started testing I noted lots of noise on the HF bands. After doing some testing with a different USB cable and a different usb port, I found a combination that cleaned up the noise.
Also, running a small wire between the N and the GND connectors on the Hi-Z port also further cleaned the signal up.
Great performance from this little radio so far!
sdrplay2.gif (99.66 KiB) Viewed 587 times
Last edited by bagmouse7 on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Return to “General”

Who is online

Users browsing this forum: JMG and 4 guests