Actualización

Discussions about everything to do with SDRuno
Post Reply
Jesús
Posts: 5
Joined: Mon Jan 15, 2018 3:26 pm

Actualización

Post by Jesús » Mon Jan 15, 2018 3:41 pm

Con la nueva actualización , el ancho de banda que había de 10 MHz a desaparecido.Solo se ve 2 MHz , aunque hay un modo que pone , 8... MHz , puesto que aunque marque esa opción no se ven más de 2mhz .
Last edited by Jesús on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Tech_Support
Posts: 499
Joined: Mon Jun 01, 2015 7:00 pm

Re: Actualización

Post by Tech_Support » Mon Jan 15, 2018 8:19 pm

Hello Jesús,
If you are only getting a maximum bandwidth of 2 MHz then you have probably selected low IF mode instead of Zero IF mode. Please open up the Settings for the Main Panel and check that you have Zero IF mode selected. 2 MHz is the maximum available bandwidth in Low IF mode.

Sincerely

SDRplay Tech_Support

Reason: No reason

Jesús
Posts: 5
Joined: Mon Jan 15, 2018 3:26 pm

Re: Actualización

Post by Jesús » Mon Jan 15, 2018 8:44 pm

No me deja , me sale que hay 2 MHz y 8.con algo , pero no se me abre más.
Last edited by Jesús on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Jesús
Posts: 5
Joined: Mon Jan 15, 2018 3:26 pm

Re: Actualización

Post by Jesús » Sun Jan 21, 2018 8:12 am

Al parecer activando IFZERO EL MUESTREO DE 10 MHZ ES VISIBLE , así que problema resuelto.
Last edited by Jesús on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Post Reply