Testing RSPduo receiver sensitivity with noise generator

General discussions
glovisol
Posts: 178
Joined: Thu May 10, 2018 6:42 pm
Location: Piedmont, Italy

Re: Testing RSPduo receiver sensitivity with noise generator

Postby glovisol » Wed Sep 12, 2018 1:10 pm

Hi Andy,
You are a keen observer, wrong series values with the attenuator in previous post!!. Better performance, easier to make shown here below.

Apologies,

glovisol
Attachments
Receiver sensitivity setup.jpg
Receiver sensitivity setup.jpg (51.47 KiB) Viewed 328 times

Reason: No reason

glovisol
Posts: 178
Joined: Thu May 10, 2018 6:42 pm
Location: Piedmont, Italy

Re: Testing RSPduo receiver sensitivity with noise generator

Postby glovisol » Tue Oct 23, 2018 3:32 pm

As written in a previous post in this same thread, it is easy to damage the Noise Source BG7TBL if using a power supply voltage of 12 V DC or higher, even though the Source is rated for up to 15 V. For safety is best never to increase supply voltage above 9 V DC. In general what happens is that one of the three wideband amplifiers in cascade blows up, but the noise generator and the other two amplifiers still work and generate a useful noise signal although at a lower output level.

It is worthwhile to try and recover the noise source by bypassing the damaged wideband amplifier, as shown in the uploaded picture. In my case it was the final stage that blew up and it was easy to solder a jumper wire across it.
Attachments
Noise source bypass.JPG
Bupass of the damaged final WB amplifier
Noise source bypass.JPG (165.43 KiB) Viewed 149 times

Reason: No reason


Return to “General”

Who is online

Users browsing this forum: No registered users and 9 guests