Sweep Control and Input Panels Missing

Information and discussions on Spectrum Analysis
Aerowerx
Posts: 4
Joined: Sun Dec 02, 2018 1:13 am

Sweep Control and Input Panels Missing

Postby Aerowerx » Fri Dec 07, 2018 3:25 am

I received my SPR1A this morning, and have been playing with both SDRuno and SAS. But since my SMA adapters have not arrived I am limited at what I can see with just a wire stuck in the input.

However, with the SAS the Sweep Control and Input Control panels are missing. Is this because I am using a Toshiba Laptop? Anyone else have this problem.

Jim
N8EE
Last edited by Aerowerx on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

SteveAndrew
Posts: 123
Joined: Thu Nov 16, 2017 11:06 pm
Location: Gold Coast, QLD, Australia

Re: Sweep Control and Input Panels Missing

Postby SteveAndrew » Sat Dec 08, 2018 10:46 pm

Aerowerx wrote:However, with the SAS the Sweep Control and Input Control panels are missing. Is this because I am using a Toshiba Laptop? Anyone else have this problem.

Hi Jim

When the analyser is launched, the initial window size is 1283 x 750. This may well be wider than your laptop screen. I can only suggest you try to decrease the width of the analyser window after it has been launched. Do you know what your screen resolution is ?

Best regards

Steve

Reason: No reason

Aerowerx
Posts: 4
Joined: Sun Dec 02, 2018 1:13 am

Re: Sweep Control and Input Panels Missing

Postby Aerowerx » Sun Dec 09, 2018 7:34 pm

Steve,

It is currently 1366x768.

I will play with it and see what it does.

Jim
N8EE
Last edited by Aerowerx on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason

Aerowerx
Posts: 4
Joined: Sun Dec 02, 2018 1:13 am

Re: Sweep Control and Input Panels Missing

Postby Aerowerx » Sun Dec 09, 2018 8:03 pm

Steve,

I hooked up a spare external monitor to my laptop. The resolution is 1920x1080, and I can now see the controls.

Jim
N8EE
Last edited by Aerowerx on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason


Return to “Spectrum Analysis”

Who is online

Users browsing this forum: No registered users and 4 guests