I received my SPR1A this morning, and have been playing with both SDRuno and SAS. But since my SMA adapters have not arrived I am limited at what I can see with just a wire stuck in the input.
However, with the SAS the Sweep Control and Input Control panels are missing. Is this because I am using a Toshiba Laptop? Anyone else have this problem.
Jim
N8EE
Sweep Control and Input Panels Missing
Sweep Control and Input Panels Missing
Last edited by Aerowerx on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
-
- Posts: 134
- Joined: Thu Nov 16, 2017 11:06 pm
- Location: Gold Coast, QLD, Australia
Re: Sweep Control and Input Panels Missing
Aerowerx wrote:However, with the SAS the Sweep Control and Input Control panels are missing. Is this because I am using a Toshiba Laptop? Anyone else have this problem.
Hi Jim
When the analyser is launched, the initial window size is 1283 x 750. This may well be wider than your laptop screen. I can only suggest you try to decrease the width of the analyser window after it has been launched. Do you know what your screen resolution is ?
Best regards
Steve
Reason: No reason
Re: Sweep Control and Input Panels Missing
Steve,
It is currently 1366x768.
I will play with it and see what it does.
Jim
N8EE
It is currently 1366x768.
I will play with it and see what it does.
Jim
N8EE
Last edited by Aerowerx on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Re: Sweep Control and Input Panels Missing
Steve,
I hooked up a spare external monitor to my laptop. The resolution is 1920x1080, and I can now see the controls.
Jim
N8EE
I hooked up a spare external monitor to my laptop. The resolution is 1920x1080, and I can now see the controls.
Jim
N8EE
Last edited by Aerowerx on Thu Jan 01, 1970 12:00 am, edited 0 times in total.
Reason: No reason
Reason: No reason
Who is online
Users browsing this forum: No registered users and 0 guests