Changes in scanner very annoying with new 1.31

Discussions about everything to do with SDRuno
sdrom33
Posts: 62
Joined: Sun Dec 09, 2018 4:38 pm

Changes in scanner very annoying with new 1.31

Postby sdrom33 » Sat Apr 13, 2019 6:18 am

Now when scanner is on many controls don't work. If I get signal with volume too low or too high I must switch off, set the volume while I do not hear nothing then switch on again. If I wish to set the squelch I must switch off and set it by ear because I not hear the noise. All this very annoying & difficult. Perhaps previous version was better why change.

Reason: No reason

Paul
Posts: 300
Joined: Fri Feb 17, 2017 9:52 am
Location: SW UK

Re: Changes in scanner very annoying with new 1.31

Postby Paul » Sun Apr 14, 2019 6:46 am

If you observe the scanner pane you will see that full functionality of SDRuno is restored when you "STOP" the scanner - not when "PAUSED."
You do NOT have to switch off the scanner - just select "STOP," then resume scan.
I hope that this may help.

Reason: No reason

sdrom33
Posts: 62
Joined: Sun Dec 09, 2018 4:38 pm

Re: Changes in scanner very annoying with new 1.31

Postby sdrom33 » Sun Apr 14, 2019 4:29 pm

Thanks Paul, very good, I had overlooked this & compliments to SDRuno staff, sometimes we do not appreciate their work!

Reason: No reason


Return to “SDRuno”

Who is online

Users browsing this forum: No registered users and 7 guests