SDRplay Community Forum

The only software that I have found that will work properly with my K3 IF (8,215,000) while using Omni-Rig is SDR Console Ver 2.3 Buld 2760. HDSDR will also work but seems a little more difficult to setup so I am currently using the SDR Console as my pan-adapter. SDR Console Ver 3 does not yet suppo...

Charlie, I too am using SDRuno with my SDRPlay as a panadapter. While reading your post I was on 17 meters so I hit the 2mtr button on the RX Control and it changed the freq to 144.000.000 without any lockup. Not sure if possibly entering the frequency differently might get other results, I rarely g...

I have been working with SDRuno utilizing my K3 IF output and everything is interfaced into the DXLab logging program. I am somewhat new to SDR software so I have been climbing the learning curve to try and understand how to achieve the most effective way to use the software. I recently wrote SDRpla...

Downloaded the new version today and see great improvements for my setup. It seems that I can now get a much smoother noise floor allowing me to see weaker cw signals.

Thanks for the update,

73
Chris
NJ5N

Thank you for your reply, I have played with the sliders and to this point it is not as easy to see on SDRuno. One of the other adjustments I see a big difference in is the RBW which is adjustable on HDSDR and my numbers are much lower than the ones on the screen for SDRuno. As you say when you star...

I am trying to make adjustments in SDRuno to better detect and see weak cw signals. This morning there are some some very weak signals on 15 meters as condx are not very good, I can detect a s1-s2 signal using HDSDR with my SDRplay and a noise floor of -130 db but when I switch over to SDRuno the si...

Thanks for the software, I have a couple of questions in getting it setup. First my setup is: SDRPlay is connected to the IF output from the K3 via my P3 scope at 8,215 MHZ with a 200khz bandwidth It appears there is no requirement to enter the IF frequency it is calculated in the software, that is ...

I am using SDRplay with HDSDR software and linked to my Elecraft K3 using DxLab's Commander. This all seems to work well with one exception and that is when I put the radio into split for working a DX station the VFO in HDSDR reflects my split frequency as it should however the actual receive is sti...