SDRplay Community Forum

A 9:1 balun, or to be exact a unun is useless at the hi-z port. Your wire will have almost any impedance depending length to frequency relation. What impedance do yo expect at a 21m wire in the 80m band? Right, very low. Transformed 9:1 results in much to low. What you need is a matching unit build ...

But you will have the same problem witch a hardware cable - you need to monitor your line/mic-input to your internal speakers.

Right click on your speaker icon, select "Recording Devices" - "CABLE Output" and then the "monitoring" tab.
Now you can enable monitoring the virtual cable and select the output device.
Works fine witch fldigi, HRD, WSJT-X and so on.
Only thing missing is a shortcut to switch monitoring on/off

Hi Lena. I've just installed the update and checked the combo view, but no flickering here. Windows 8.1 Maybe the following will help to find out the problem: Intel(R) HD Graphics 3000 Report Date: 1/14/2018 Report Time[hh:mm:ss]: 10:02:24 Driver Version: 9.17.10.4229 Operating System: Microsoft Wi...

Looks good and works fine so far, but there is one thing not so nice - the SP1 window is flickering so much you could not watch a long time.
I'm using the combo view and same settings as in vers 1.21.
But your todo list looks nice, so looking forward

73 Lena

Hey, nice to hear!
So long I can live with my work around.
I don't want to use another program, because I like SDRuno very much and at the moment I have a lot of other things to learn.

73 Lena

But sometime you like to have a "special" LO frequency. In my case I like to monitor two relays and two often used local frequencies. So I like to have my LO in the middle of them. Therefor I store this frequency labelled "start" and lock it after start-up to prevent shifting all rx when clicking in...

Not really quick, but dirty?
Set you main receiver to the desired frequency, quit SDRuno and start it again.
After that I locked the frequency immediately and set the receivers to my favourite frequencies.

OK, the favorites are stored separately and are ready to use.
I have found the other settings in the registry and vers 1.2 has created a new set of settings, leaving the old settings untouched.
So, is there a way to transfer these settings to the new version?

Hey,
i have updated from vers. 1.1 to 1.2 and all my settings, including my stored favorites are gone
Is there a way to get them back?
Thanks, Lena