First, let me say again how much I appreciate all the help.
Lots to learn, and, frankly, it isn't too easy for me now. But working on it.
(Have read the Manual, several times; will be starting on all the YouTube Videos on it next)
Have a RSP-2. Really enjoying it.
a. I have essentially no good understanding of the "IF Mode" function and the "LIF" button.
Could someone please give me a few words on when one uses which, and what it should be for the various modes, etc. ?
Before I just did a restore to the factory defaults, I had in Main/Settings (I think) a Zero IF and Low IF. Don't seem to show now ?
What are/were these, and how should they be set "
b. Re that spike that often appears in the middle of the spectrum:
I am assuming it is from the LO.
Is this something you just live with, or is there an "easy" way to not have it show ? Notch out ? Or,...?
c. What's the usual/best way of adjusting the span of the Spectrum that shows ?
Discussions about everything to do with SDRuno
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests