SDRplay Community Forum

This forum is now suspended and will not accept any new posts or account registrations. For technical support relating to SDRplay hardware or software, please open up a support ticket via www.sdrplay.com/support
https://www.sdrplay.com/community/

Saving Workspace

https://www.sdrplay.com/community/viewtopic.php?f=11&t=1063

Page 1 of 1

Saving Workspace

Posted: Thu Sep 22, 2016 11:52 am
by josephlevy
Hi all
RSP on win10 (and XP)

saving a workspace saves the positions and modes but not the frequencies of the windows or the stations on VFOa or VFOb in all the windows!

Instead it brings the correct positions of all saved windows but with the frequency of VRX0 in all VRXs.

Can somebody enlighten me (ie tell me how to do it properly so I don't have to tune all opened widows again every time I run SdrUno?

Re: Saving Workspace

Posted: Thu Sep 22, 2016 12:34 pm
by sdrplay
The only frequency stored is the VRX#0 frequency. We will be addressing this in a future release.

Best regards,

SDrplay Support

Re: Saving Workspace

Posted: Fri Sep 23, 2016 8:57 am
by g8ixn
The only frequency stored is the VRX#0 frequency. We will be addressing this in a future release.
It would also be useful if the modes & filters were stored too.
Like VFO A "103.9 mhz" SWFM VFO B "145.725" NFM de emph or not etc
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/